Checkout Our Current Sale Items, Click Here To Save Now!
Adding product to your cart
DuroBumps are quality made in the USA with dual durometer (hardness) rubber, to deliver smooth, progressive dampening that reduces hard bottom-outs significantly and allows for greater control and comfort. OEM bump stops tend to feel rock-hard on contact. DuroBumps eliminate that hard bump.
The DuroBumps DBF24R is slightly taller than OEM bump stops because the DuroBumps compresses under load to lessen the impact just before the ultimate stop. The DBF24R will not limit your wheel-up travel.
It's designed to replace the rear-mounted OEM bump stop on the front passenger and driver sides of the truck.
The DBR24R is the only aftermarket bump stop designed with a 14 Degree taper, ensuring even contact upon engagement. Other manufacturers don't list the third-gen 4Runner and first-gen Tacoma in their product applications, let alone have the required 14 Degree angle built into the design. Features and benefits
Note: For off-road use only. By installing these aftermarket bump stops on your vehicle, you assume all risk and liability. DuroBumps are not designed for towing applications.
Part DBF24R: Front Bump StopsWhat's included: (2) Two front DuroBumps(2) Two JIS 10.9 M10 1.25 mm x 35 mm flange bolts(1) Single-use medium thread locker(1) One FREE sticker Tools required:
Instructions:Pre-soak OEM bump stop with penetrating oil to make removal easier. Pay careful attention to the threaded stud that mounts the bump stop to the frame and the threads of the stud that are exposed beyond the nut. Step 1: Following vehicle manufacturer recommendations, use a properly rated jack. Raise the front of the vehicle, and support the frame rails with jack stands. Remove front wheels from truck. Be sure to use jack stands! Step 2: Remove OEM bump stops with groove-lock pliers, pipe wrench, or similar. The bump stop is located on the rear of the lower control arm on the driver and passenger sides of the vehicle. Be careful not to break the threaded stud on the OEM bump stop during removal. Step 3: Use a scraper or wire brush and clean any mud/ debris from the frame. Step 4: Insert provided flange bolt into the new front DuroBumps and coat the threads with the provided single-use medium (blue) thread locker. Step 5: Install the DuroBumps at the rear of the lower control arm, using a 14mm deep socket. Tighten the bolt until snug (12 - 15 ft. lbs.) Do not over tighten. The OEM bump stop that is located at the front of the lower control arm will remain in place. Step 6: Reinstall wheels and lower vehicle back to the ground. Be sure to tighten lug nuts to vehicle manufacturer's recommendations. Please note: DuroBumps are intended to be installed at the rear of the lower control arm only.Now go hit some trails or cruise the mall ... whatever you're into!
Promotions, new products and sales. Directly to your inbox.
No products in the cart.